Overview
CALDON Hydro Transducers for Large Pipes
8001 transducers and 8002 feedthrough assemblies are designed for installation on exposed pipes and penstocks from 42" to 27 ft in diameter. This is a 1-MHz transducer suitable for high-accuracy measurement in large pipes. The feedthrough assembly is designed to allow retraction and removal of the transducer while the pipe is under pressure. In addition, the 8001/8002 incorporates dual retaining pins and a tamper-resistant pin guard/retainer, features that are not available elsewhere.
8003 transducers and 8004 feedthrough assemblies are designed for installation on exposed pipes and penstocks from 20" to 48" in diameter. These assemblies are specifically designed for use in smaller pipes where protrusion of the transducers into the flow is minimized in order to maintain high measurement accuracy. However, the transducer still retains a radial feedthrough for ease of installation on existing pipes. Additionally, the feedthrough design utilizes a standard Thread-O-Let® fitting.
CALDON Hydro Transducers for Buried Pipes and Tunnels
8010 transducers and 8011 mount assemblies are designed for installation in buried pipes and tunnels from 5 ft to 25 ft in diameter. This is a 1-MHz transducer suitable for high-accuracy measurement in large conduits.
8005 transducers and 8006 mount assemblies are designed for installation in buried pipes and tunnels from 8 ft to 35 ft in diameter. The 8006 is a low-profile mount assembly designed to minimize flow disturbance over the transducers. The assembly incorporates a waterproof connector to allow transducer replacement without splicing or rerouting cables.
